The production of energy systems formed from different solar panels and fuel cells by using micro-controller automation

Nowadays, the production of electricity from renewable energy sources by using the wind energy and using the density solar energy is preferred. Even the converting of wind energy sources and using the reflection of solar energy without charge into electrical energy but initially also depends on the cost of setting up the system. The using of wind turbines for production electricity in achieving photovoltaic system is located incidental sunlight into electrical energy directly into the conversion of solar panels. The important part of the wind turbines in achieving photovoltaic system is located incidental sunlight into electrical energy directly into electrical energy converts solar panels. The efficiency which has been obtained in the production of solar panels is variable according to the semiconductor. In this study; the mono crystalline, polycrystalline and thin film formed from solar panels and electric power flow control which have been produced independently of the three photovoltaic systems is carried out. With each solar panel of control system designed to control the flow of energy , electrical energy is produced by the electrical energy which they have taken the load , the charge - discharge state of the battery are monitored. In this case, the electricity which generated to the energy flow control algorithm for determining the proper feeding of the system which ensured that consumers have been done at the same time charging the battery. For realization microcontroller of a hybrid fuel cell system consisting of solar panels and energy flow control board and C #, all data in the control system with the help of software has been done on the computer screen in 10 sec interval. Rate of benefits from the electricity which generated by making the analysis of the recorded data, which was found that while consumers remain energized is obtained. At the same time consumers are fed up with what energy he has collected over the battery group is determined approximately.