Experimental investigation of the effect of different chip breaker forms on cutting forces and surface roughness in turning of aisi 304 stainless steel
Is this your thesis?
This record came from a bulk archive import. If it’s yours, link it to your profile.
Abstract (EN)
In this study, the effect of different chip breaker forms on cutting forces and surface roughness during chip removal process has been investigated experimentally. AISI 304 grade austenitic stainless-steel material was machined by the cutting tools with an ISO notation of WNMG O80408 EA, WNMG 080408 EM, WNMG 080408 MP and the effects of these factors on cutting forces and surface roughness values were determined. In the experimental studies, the highest cutting forces were obtained by the cutting tools with the EM coded chip breaker form and the best surface quality was obtained by the MP coded cutting tool.
Author
Buğra Arslan
How to Cite
Buğra Arslan (Master Thesis). Experimental investigation of the effect of different chip breaker forms on cutting forces and surface roughness in turning of aisi 304 stainless steel, 2019, Konya Technical University.
Keywords
License
Tüm Hakları Saklıdır
This work is shared under the specified license terms.
More theses from Konya Technical University
- A study on the preparation of block planning principles in land consolidation projects(2023)
- Deep learning based visual and inertial data fusion for uav localization in case of GNSS signal losses(2025)
- Comparison of some manufacturing costs according to various analysis parameters and other regulations of reinforced concrete structures with different floor systems(2018)
- Evaluation of the rail transportation network relations with urban transformation projects by the traffic impact analysis method: A case study of the old industry in Konya(2019)
- Ahmet Hilmi Nalçacı as a leading person in the development of municipality in Konya(2019)
- The use of olive seed powders in vehicle brake pads and investigation of wear properties(2019)