Experimental investigation of the effect of hydrogen-assisted flame jet ignition system's in-cylinder combustion, engine performance and exhaust emissions in a direct injection gasoline engine
Is this your thesis?
This record came from a bulk archive import. If it’s yours, link it to your profile.
Abstract (EN)
In this thesis study, a two-cylinder, water-cooled and manifold injection spark ignition engine was modified to have a direct injection (DI) fuel system and a hydrogen-assisted flame jet ignition (HAJI) system with a pre-combustion chamber integrated into each cylinder of the engine. The engine's spark plugs were mounted on the HAJI system and the air-fuel mixture in the main combustion chamber was ignited with the flame jet provided by the H2 sprayed into the HAJI (active operating conditions of HAJI). In the experimental setup, a hydraulic dynamometer was connected to the output shaft of the engine to ensure that the engine operates under different load and speed conditions. The main fuel, gasoline, was injected into the cylinder via DI at a pressure of 90 bar, and H2 gas was injected into the HAJI system via a DI injector at a pressure of 5 bar. Injection advance and duration of both gasoline and H2 were controlled with the help of two electronic control units. Injection advances of gasoline and H2 fuels and ignition advance in HAJI were optimized through a series of preliminary experiments. Experiments were carried out at a constant engine speed of 2300 rpm and ½ throttle opening ratio, with 5 different air/fuel mixture ratios (λ = 0.8, 0.9, 1.0, 1.1 and 1.2) in the main combustion chamber. It was carried out using the optimum H2 flow rate determined for each λ in HAJI (0.0, 0.5, 1.0, 1.5, 2.0, 2.5 and 3.0 L/min). In experimental studies, change data of in-cylinder pressure depending on the crank angle, temperature data taken from different points of the engine and exhaust gas emissions (HC, CO, NOx and CO2) change data were obtained. With the obtained data, indicated mean effective pressure (IMEP), pressure rise rate (PRR), in-cylinder average gas temperature, heat release rate (HRR), mass fraction burned (MFB), coefficient of cyclic change in IMEP (COVIMEP), indicated engine power, indicated engine torque, indicated thermal efficiency, indicated specific fuel consumption and combustion efficiency were calculated. Results obtained, in the gasoline direct injection engine, when the air/fuel mixture in the main combustion chamber is advanced from λ = 0.8 rich mixture to λ = 1.2 lean mixture, the amount of H2 that needs to be injected into the HAJI system to obtain optimum engine performance and in-cylinder combustion conditions increases (optimum H2 flow rate is 0.5 l/min at λ = 0.8 and optimum H2 flow rate is 2.5 l/min at λ = 1.2). It has been shown that especially in lean mixtures (λ = 1.1 and λ = 1.2), the HAJI system increases the effect on in-cylinder combustion (IMEP, PRR, HRR, MFB and COVIMEP), indicated engine performance and exhaust emissions. For example, when comparing passive combustion conditions in which H2 is not injected into HAJI under λ = 1.2 lean mixture combustion conditions and active combustion conditions in which optimum H2 injection is made in HAJI (optimum H2 flow rate in HAJI is 2.5 L/min), 62.27% increase in maximum pressure, 161.82% increase in maximum PRR, 14.08% increase in maximum in-cylinder average gas temperature and 12.78% increase in maximum HRR, 33.33% decrease in total combustion time (100% MFB) and 60.37% decrease in COVIMEP are achieved. In addition, a 20.27% increase in IMEP, a 23.15% increase in indicated engine power, a 23.22% increase in indicated engine torque, a 20.79% increase in indicated thermal efficiency and an 18.75% decrease in indicated specific fuel consumption were achieved. When the changes in exhaust emissions are examined, there is a 77.80% decrease in HC, an 87.50% increase in CO, a 312.33% increase in NOx and a 35.48% increase in CO2.
Author
Ümit Topalcı
Institution
How to Cite
Ümit Topalcı (Doctorate thesis). Experimental investigation of the effect of hydrogen-assisted flame jet ignition system's in-cylinder combustion, engine performance and exhaust emissions in a direct injection gasoline engine, 2024, Süleyman Demirel University.
Keywords
License
Tüm Hakları Saklıdır
This work is shared under the specified license terms.
More theses from Süleyman Demirel University
- The women muhaddithat of the 8th century (With special attention to Imam Adh-Dhahabi's teachers)(2024)
- Investigation of anatomical variations important for functional endoscopic sinus surgery on computed tomography images(2024)
- KOSGEB practices on the new public management and governance axis: Western Mediterranean and Denizli examples(2024)
- Urban transformation in medium-sized cities: satisfaction in the example of Uşak (Atapark and Tabakhane)(2024)
- A research on the elements affecting the price of precious metals and the causality relationships(2024)
- International communication functions of diplomatic journalism: A review on Turkey(2024)
