The calculation of dose for nuclear radiation dosimetric targets using monte carlo method
2011
0 görüntülenme
0 i̇ndirme
Danışman: Prof. Dr. Ayşe Güneş Tanır
Özet (EN)
The main goal of this study is experimentally calculating the dose released by photons within the media that they proceed that are emitted as a result of pair annihilation of positrons of radioactive isotope used in positron emission tomography and compare them with the results achieved by Monte-Carlo method. Brain was selected as the target organ in our study. The dose released by photons during the course of their progress in brain during PET imaging with brain protocol was determined empirically by placing TLD in jaszczak phantom at certain intervals and placing F-18 FDG source with different activities to the centre of phantom and then making TLD readings after PET scanning. Modeling was performed for sources of photon and positron to be point and cylindrical in MNCP by Monte-Carlo method in line with experimental study geometry and estimated diagnostic doses were compared with the results of experimental PET scans. Moreover, doses acquired with brain protocol during CT and PET/CT scans with TLDs placed at phantoms were determined by TLD readings. Stopping power calculations were made with brain and LiF materials by using analytical forms used by Gümüş (2008). Stopping powers were calculated from the dose and flux values obtained by modeling with point positron source at MNCP by using Monte Carlo method and these were compared with analytical results and ICRU 37 data.
Yazar
Sinem Keleş
Bu Yayına Nasıl Atıf Yapılır
Sinem Keleş (Doctorate thesis). The calculation of dose for nuclear radiation dosimetric targets using monte carlo method, 2011, Gazi University.
Anahtar Kelimeler
Lisans
Tüm Hakları Saklıdır
Bu eser belirtilen lisans koşulları altında paylaşılmaktadır.
Gazi University tezlerinden daha fazlası
- Occupational accident analysis and modelling in oil and gas drilling sector Turkey(2021)
- XVI. yüzyıl Anadolu'sunda Oğuzların Karkın Boyu(2004)
- Sharing of real life geometry samples via a social learning environment: A case study(2021)
- Evaluatıon of calcium hydroxide removal efficiency of two different irrigation activation techniques from artificial internal resorption cavities prepared at different root levels(2021)
- Experimental development of the interfacial bond-slip model between textile reinforced mortar strips and masonry walls(2025)
- The use of verbal memory in the context of sustainability and power at the museums of Turk(2010)
