Stress analysis of pump gears produced with P/M method
2008
0 views
0 downloads
Advisor: Dr. Hakan Çetinel
Abstract (EN)
In this study, hydraulic pump gear set produced with P/M (Powder Metallurgy) techniques, are examined with different mechanical properties and then the stresses ocur on the gear body are compared. The 3-D model of the gear set obtained from the manufacturer is built after the CMM (3-D scanning) operation. The tooth contact stres has been calculated under particular operation conditions of the hydraulic pump. Then this value and the mechanical properties obtained from the powder metal manufacturer has been used in analysis with ANSYS WORKBENCH software. In these analysis, sintering temperature and the mechanical properties due to sintered density value variations are used to determine the stres distribution.It was found out that the sintered density is the primary factor effecting on the mechanical properties.
Author
Dr. Burak Yılmaz
Institution
How to Cite
Burak Yılmaz (Master Thesis). Stress analysis of pump gears produced with P/M method, 2008, Manisa Celal Bayar University.
Keywords
License
Tüm Hakları Saklıdır
This work is shared under the specified license terms.
More theses from Manisa Celal Bayar University
- Corporate sustainability perceptive and practices: Analyzing the sustainability reports of Turkey's most valuable brands(2023)
- Survey of equi-integrity value in graphs(2023)
- A review of renewable energy, economic growth and wind energy: Example of selected OECD countries(2023)
- Applications of traffic simulation in intersection design - Bursa city gürsu intersection example(2023)
- H. 1326-1329/ M. 1908-1911 tarihli 419 numaralı Manisa Şer'iyye Sicili transkripsiyonu ve değerlendirilmesi(2023)
- Examination of key audit areas in the Turkish metal industry(2023)